MITEL 6900, 6970, 6800, AND 6700 SIP TERMINALS FOR MIVOICE MX-ONE
13 26/1531-ANF 901 14 Uen S 2019-10-18
Once the user has logged in, MX-ONE push out a log out key. In case the user would
exit the logon prompt, there is an XML logon key configured in <model>.cfg:
softkey5 label: “Log on”
softkey5 type: xml
softkey5 value: http://$$PROXYURL$$:22222/Logon
softkey5 states: idle
softkey5 line: 1
7.3.3 VISITOR DESKPHONE [HOTDESKLOGIN KEY]
Visitor Deskphone (VDP), only supported for 6900/6800, is a native phone function for
user login and logout. The function is derived from the 8000i video phone. When
HOTDESKLOGIN KEY is pressed the phone will prompt for user and password. VDP
is described in the documents “Mitel 6800/6900 Series SIP Phones, Release 5.0.0
ADMINISTRATOR GUIDE”.
VDP introduces user scope. Anything configured by the user or MX-ONE while logged
in using the HOTDESKLOGIN KEY is stored in user scope and will be lost at logout
unless it is saved by the MX-ONE program unit, ConfigServer, reading the uploaded
<user>_local.cfg.
The phone will log out the user (and clear user scope data) at reboot, but the user data
is kept on power failure, so it will be logged on again when power comes back.
Only speeddials are read and stored in MX-ONE system database as TNS keys. The
user can only program the speeddial when logged in if it shall be uploaded to MX-ONE.
If a key is shown while logged off it is programmed in a local host scope (not in hotdesk-
login user scope), this key will not be converted into user scope after being logged on
and therefore not uploaded and saved in MX-ONE. Local host configuration are erased
doing “reset - Erase Local Cfg.” on the phone or its web GUI.
In order to keep call logs, central call log should be enabled via, extension_profile -c
--csp <csp> --ext-cnnlog 1. When enabled, MX-ONE (SIPLP) will push out the neces-
sary configuration to the phone in the registration process.
Directory items added by the user via the phone ‘local directory’ will be lost at logout.
As VDP is only supported on 6900/6800, only the startup.cfg (which is only read by
6900/6800) template contains the required settings.
user config url:http://10.105.64.201:22225/vdp*)
user config upload: 1**)
user config upload delta: 0 #No random delta for upload
user config upload control: 2***)
hot desk high security: 0 #Accept to logout without password
*) MX-ONE program unit ConfigServer listens on port 22225 (set in
/etc/opt/eri_sn/ip_telephony.conf). This program manages <user>.cfg and
<user>_local.cfg GET requests and POST (upload) of <user>_local.cfg.
**)The time in seconds which the phone will check whether there is something new to
upload.
***) (2) phone will push to MX-ONE only if there is a change on the phone.
In summary the phone will check frequently whether there is a change, but it will only
upload <user>_local.cfg if something has changed.
The hotdesk login key is set in the 68xx.cfg (or 69xx.cfg) file
softkey5 type: hotdesklogin
softkey5 states: idle
To Next Page
Loading...
