26/1531-ANF 901 14 Uen S 2019-10-18 30
C
ONFIGURING THE PHONE
• speeddialxfer (the softkey is configured to transfer calls and configured for
speed dialing to a specific number.)
• speeddialconf (the softkey is configured as a speed dial key and as a confer-
ence key.)
• phone lock (the key is used to lock / unlock the phone).
• none (the softkey is not used [default])
• empty (the softkey is configured to force a blank entry on the phone display
• mobile (6930 and 6940 SIP phones (not 6920) support the key type mobile
The following keys that are pushed out from MX-ONE Service Node and can not be
changed via MX-ONE Service Node Manager, they need to be edited manually in
config file /etc/opt/eri_sn/ip_telephony.conf.. (If the key values are set to “”, they are
not pushed to the phone). This file must be changed in all servers in the system. At
upgrading of the MX-ONE software this file have to be edited again. ‘restart -u SIPLP’
is required after the file is edited to activate changes.
• Logon/Logoff
• Diversion
• ExtensionKeyDeafult;{none[default] | empty}
Per the switch ExtensionKeyDefault is set to none. So at Logoff, the Diversion key and
all individual keys will be set as key type none. However in case all not used keys are
set to empty in <model>.cfg, the system needs to set unconfigured keys to empty.
The first individual key index and key base (prgkey,softkey or topsoftkey) is also set via
ip_telephony.conf
The <MAC>.cfg can be used for a phone to override the default key layout. You may
decide that the a specific phone shall have an extension number which shall not be
logged off and not to be used for free seating. See Chapter “Logon/Off Key Not Used”.
See also 8.2 Installing the Firmware / Configuration files on page 17.
The default key layout for the different models is shown below.
To Next Page
Loading...
