Mitsubishi Electric MELSEC iQ-R Series - Random Write in Bit Units (Test) (Command: 1402)

110
8 DEVICE ACCESS
8.3 Random Read and Write
Random write in bit units (test) (command: 1402)
Write values to devices in bit units. It can be specified with discontinuous device number.
When accessing any of the following devices, use the device extension specification (subcommand: 008).
• Link direct device
• Module access device
• CPU buffer memory access device
For the message format for device extension specification, refer to the following section.
Page 438 Read/Write by Device Extension Specification
Message format
The following shows the message format of the request data and response data of the command.
■Request data
■Response data
There is no response data for this command.
Request data
■Command
■Subcommand
For 2C frame, the specification is not required. Functions and specification methods are equivalent to the subcommands for
MELSEC-Q/L series.
■Number of bit access points
Specify the number of device points to be written within the following range. (Page 72 Number of device points)
Frame ASCII code Binary code
4C/3C/4E/3E frame
2C frame 
Type ASCII code Binary code
For MELSEC-Q/L series
For MELSEC iQ-R series
Access target Range
MELSEC iQ-R series module (subcommand: 0001)
MELSEC-Q/L series module (subcommand: 0001)
1 to 188 points
MELSEC iQ-R series module (subcommand: 0003, 008)
MELSEC-Q/L series module (subcommand: 0081)
MELSEC-QnA series module
Module on other station via MELSEC-QnA series network module
1 to 94 points
MELSEC-A series module 1 to 20 points
Device
(first point)
Set/reset
(first point)
Device
(nth point)
Set/reset
(nth point)
Command Subcommand
Number of bit access
points (n points)
1
31H
4
34H
0
30H
2
32H
02 H 14 H
6
36H
0
30H
0
30H
0
30H
1
31H
01H 00H
0
30H
0
30H
0
30H
3
33H
03H 00H