Mitsubishi Electric MELSEC iQ-R Series - PC no

18 COMMUNICATING USING 1E FRAMES
18.2 Details of Setting Data
393
18
PC No.
Specify the station No. of the access target.
Accessing the connected station (host station)
Specify 'FF'.
Accessing other stations via network
Specify the network module station No.01H to 40H (1 to 64) of the access target.
Setting method
■Data communication in ASCII code
Convert the numerical value to 2-digit ASCII code (hexadecimal), and send it from the upper digits.
■Data communication in binary code
Send a 1-byte numerical value.
Ex.
Accessing the connected station (host station)
When accessing other station of network station No. '3'.
The station No. of the network module can be checked by using the following parameters of Engineering tool.
• GX Developer and GX Works2: "Network Parameter"
• GX Works3: "Module Parameter"
The network module station No. is set in decimal. However, the PC No. is set in hexadecimal.
When specifying the network of the access target is required, set "Valid Module During Other Station Access"
with an Engineering tool.
ASCII code Binary code
ASCII code Binary code
External device
Connected station
(Host station)
:Access target station
External device
Network
Other station
Connected station
(host station)
:Access target station
46H
46H
FF
FFH
30H
33H
0
3
03H