Mitsubishi Electric MELSEC iQ-R Series - Modify File Creation Date and Time (Command: 1826)

12 FILE CONTROL
12.6 File Modification
233
12
Modify file creation date and time (command: 1826)
Modify the file creation date and time.
When this command is executed to files of parameter and a program being executed, place CPU module in
the STOP status. (Page 463 Commands that cannot be executed during RUN)
Message format
The following shows the message format of the request data and response data of the command.
■Request data
■Response data
There is no response data for this command.
Data specified by request data
■Command
■Sub command
■Fixed value
Specify '0'.
■Drive No.
Specify the access target drive. (Page 198 Drive No.)
■Date to change, time to change
The file of the last edit date and time is modified with the specified date and time. (Page 206 Creation date and time (last
edit date and time))
■Number of file name characters, file name
Specify the file name to modify attribute. (Page 202 File name specification)
ASCII code Binary code
Item ASCII code Binary code
For MELSEC-Q/L series
For MELSEC iQ-R series
ASCII code Binary code
Subcommand
Fixed
values
Drive No.
Date to
change
Time to
change
Number of file
name characters
File nameCommand
1
31H
8
38H
2
32H
6
36H
26 H 18 H
0
30H
0
30H
0
30H
0
30H
00 H 00 H
0
30H
0
30H
4
34H
0
30H
40 H 00 H
0
30H
0
30H
0
30H
0
30H
00H 00H 00H 00H