15 QnACPU DEDICATED COMMANDS
15.3 File Control
335
15
Delete file (command: 1205)
The following examples show the procedure to delete the existing files.
Determine the file deletion timing for the entire system, including the QnACPU and related devices.
The file in which the file lock has been registered cannot be deleted.
When QnACPU is in RUN, the following files cannot be deleted.
• Program file (.QPG)
• Parameter file (.QPA)
• Boot setting file (.QBT)
Message format
■Request data
■Response data
There is no response data for this command.
Data specified by request data
■Command
■Subcommand
■Keyword
Allow/prohibit the access to the file of the target memory. (Page 298 Keyword)
■Setting flag
Data that indicates whether the keyword is registered in the specified drive. (Page 298 Setting flag)
■Drive name
A data to specify the drive in a CPU module of which files are to be managed. (Page 298 Drive name, Drive No.)
■File No.
A data to specify the registration number of files. (Page 298 File No.)
■File name
Character string data of a file name. (Page 299 File name, extension, and attribute)
ASCII code Binary code
ASCII code Binary code
ASCII
Subcommand Keyword Setting flag Drive name File No. File name
Extension
Attribute
Binary
Setting
flag
Keyword
Drive
name
File No.
File name
Extension
Attribute
Subcommand
To Next Page
Loading...
