52
6 ACCESS ROUTE SETTINGS
6.2 Details of Setting Data
Network No., PC No.
Specify the network No. and station No. that are set with the parameters for the access target network module.
Specify a fixed value when accessing the connection station.
Specify the network No. with the value shown below.
Specifying improper value may result in no response returned.
Accessing the connected station (host station)
Specify '0' for the network No., and 'FF' for the PC No.
■When using the on-demand function
Specify '0' for the network No., and 'FE' for the PC No.
(Page 280 On-demand function)
Accessing multidrop connection station
Specify '0' for the network No., and 'FF' for the PC No.
Accessing other stations via network
Specify the network No. and station No. of an access target.
*1 Access the station set as a control station/master station by parameters.
*2 Access the station which is operating as a control station/master station.
Access target Network No. PC No.
Other station of which station No. is set 01H to EFH (1 to 239)
Stations with network No.240 to 255 are not accessible.
01H to 78H (1 to 120)
Specified control station/master station
*1
7DH
Current control station/Master station
*2
7EH
External device
Connected station
(Host station)
:Access target station
External device
Multidrop connection
:Access target station
Network
No.n
:Access target station
Other stations
External device
Connected station
(Host station)
To Next Page
Loading...
