Mitsubishi Electric MELSEC iQ-R Series - Read Registered Data (Command: 0610)

13 SERIAL COMMUNICATION MODULE DEDICATED COMMANDS
13.1 User Frame
249
13
Read registered data (command: 0610)
Read the registered content of user frames.
Message format
The following shows the message format of the request data and response data of the command.
■Request data
■Response data
The read registration data is stored.
Data specified by request data
■Command
*1 For C24, an additional code is added. (Page 35 Additional code (10H))
■Subcommand
■Frame No.
Specify the number of user frame to be read. (Page 247 Frame No.)
When the frame No. whose user frame is not registered is specified, an error occurs and an abnormal
response is returned.
Data to be stored by response data
■Number of registration data byte, number of frame byte
The data byte count of the registration data is stored. (Page 247 Number of registration data byte, number of frame byte)
■Registration data
The data content of user frames to be registered is stored. (Page 248 Registration data)
ASCII code Binary code
*1
ASCII code Binary code
Type Setting value Registration destination
Default registration frame 1H to 3E7H ROM for C24 operating system
User frame 3E8H to 4AFH Flash ROM of C24
8001H to 801FH Buffer memory of C24 (addresses 1B00H to 1FF6H)
Subcommand
Command Frame No.
Registration data
byte count
Frame byte
count
Registration data
0
30H
6
36H
1
31H
0
30H
10 H 06 H
DLE
10
H
0
30H
0
30H
0
30H
0
30H
00 H 00 H