Mitsubishi Electric MELSEC iQ-R Series - Page 307

15 QnACPU DEDICATED COMMANDS
15.3 File Control
305
15
Copy mode
A data to specify whether or not the last edit data and time of the source file to the target file at the completion of copying.
The QnACPU management time at a new file creation will remain when the date and time are not copied.
■Data communication in ASCII code
Convert the numerical value to 4-digit ASCII code (hexadecimal), and send it from the upper digits.
■Data communication in binary code
Send 2-byte numerical value from the low byte (L: bits 0 to 7).
■Specified value and contents of the copy mode
Setting value Content to be specified
0000H Do not copy the last edit date and time of the source file at completion of copying.
0001H Copy the last edit date and time of the source file at completion of copying.