Mitsubishi Electric MELSEC iQ-R Series - Page 332

330
15 QnACPU DEDICATED COMMANDS
15.3 File Control
• Batch modify file information (subcommand: 0002)
■Response data
There is no response data for this command.
An error occurs If one of the following files is specified while the QnACPU is in RUN, and error end code will
be returned.
• Parameter file
• Currently executing file in the built-in RAM (drive name: 00H)
ASCII
Subcommand
Keyword Setting flag Drive name File No.
File name
(Before modification)
Extension
(After modification)
Attribute
(Before modification)
Modification pattern
File name
(After modification)
Extension
(After modification)
Attribute
(After modification)
Last edit time
Last edit date
File size
Fixed value
Binary
Setting
flag
Keyword
Drive
name
File No.
File name
(Before
modification)
Extension
(Before
modification)
Attribute
(Before
modification)
Modification
pattern
File name
(After
modification)
Extension
(After
modification)
Attribute
(After
modification)
Last edit
time
Last edit
date
File size Fixed
value
Subcommand