Mitsubishi Electric MELSEC iQ-R Series - Page 56

54
6 ACCESS ROUTE SETTINGS
6.2 Details of Setting Data
Setting method
■Data communication in ASCII code
Convert the numerical value to 2-digit ASCII code (hexadecimal), and send it from the upper digits.
■Data communication in binary code
Send a 1-byte numerical value.
Ex.
Accessing connected station (host station) or multidrop connection station
When accessing other station of which network No. is '2' and station No. is '3'
The network No. and station No. of the network module can be checked by using the following parameters of
Engineering tool.
• GX Works2: "Network Parameter"
• GX Works3: "Module Parameter"
The network No. and the station No. of the network module are normally set in decimal. However, the network
No. and the PC No. are set in hexadecimal.
ASCII code Binary code
ASCII code Binary code
30 H 30 H 46 H 46 H
00 FF
Network
No.
PC
No.
00H FFH
Network
No.
PC
No.
30 H 32 H 30 H 33 H
02 03
Network
No.
PC
No.
02H 03H
Network
No.
PC
No.