Mitsubishi Electric MELSEC iQ-R Series - Page 85

8 DEVICE ACCESS
8.1 Data to be Specified in Commands
83
8
Monitor condition
Following conditions can be specified as "Monitor condition" for read timing.
When the step No. specification and device specification are specified together, the read processing is performed when both
of the conditions are satisfied.
Specify the following values according to the conditions.
: Specified, : Not specified
Conditions that can be specified Condition satisfaction timing
Step No. specification When specified program step is executed
Device specification Word device value specification When specified word device value reached the specified value
Bit device value specification When specified bit device turned ON/OFF
Step No.
specification
Device specification ASCII code Binary code

Word device value
specification

Bit device value
specification

0
30H
1
31H
0
30H
F
46H
01 H 0F H
0
30H
2
32H
0
30H
F
46H
02 H 0F H
0
30H
3
33H
0
30H
F
46H
03 H 0F H
0
30H
4
34H
0
30H
F
46H
04 H 0F H
0
30H
5
35H
0
30H
F
46H
05 H 0F H