4G6 ENGINE (E-W) -
Crankshaft, Flywheel and Drive Plate
11A-12-7
(4) Bore all cylinders to the calculated boring finish dimension.
Caution
D
To prevent distortion that may result from
temperature rise during honing, bore cylinders,
working from No. 2, No. 4, No. 1 to No. 3.
(5) Hone to final finish dimension (piston O.D. + clearance
between piston O.D. and cylinder).
(6) Check clearance between piston and cylinder.
Clearance between piston and cylinder:
0.02 - 0.04 mm
NOTE
When boring cylinders, finish all of four cylinders to same
oversize. Do not bore only one cylinder to an oversize.
AddedPWEE9616-A
E
Aug. 1998Mitsubishi Motors Corporation
To Next Page
Loading...
