4G6 ENGINE (E-W) -
Rocker Arms and Camshaft
11A-8-6
(15)Fit special tool MD998441 onto the lash adjuster.
(16)Place the lash adjuster in container C again, then gently
push down the internal steel ball using special tool
MD998442.
(17)Stand the lash adjuster with its plunger at the top, then
push the plunger downward firmly until it moves through
its greatest possible stroke. Return the plunger slowly,
then release the steel ball and allow the pressure chamber
to fill with diesel fuel.
(18)Remove special tool MD998441.
(19)Remove the lash adjuster from the container, then stand
the lash adjuster with its plunger at the top. Push the
plunger firmly and check that it does not move. Also,
check that the lash adjuster’s height matches that of a
new lash adjuster.
NOTE
If lash adjuster contracts, perform the operations (15)
through (19) again to fill it with diesel fuel completely.
Replace the lash adjuster if it still contracts after performing
these steps.
(20)Stand the lash adjuster upright to prevent diesel fuel
spilling out. Do not allow the lash adjuster to become
contaminated by dirt or other foreign matter. Fit the lash
adjuster onto the engine as soon as possible.
MD998442
Diesel fuel
MD998441
AddedPWEE9616-A
E
Aug. 1998Mitsubishi Motors Corporation
To Next Page
Loading...
