Mitsubishi MELFA CR1D User Manual

4MELFA-BASIC IV
Detailed explanation of command words 4-246
[Explanation]
(1) If the condition matches one of the Case items, the process will be executed until the next Case, Default
or EndSelect. If the case does not match with any of the Case items but Default is described, that block
will be executed.
(2) If there is no Default, the program will jump to the step after EndSelect without processing.
(3) The Select Case and End Select statements must always correspond. If a GoTo instruction forces the
program to jump out from a Case block of the Select Case statement, the free memory available for
control structure (stack memory) decreases. Thus, if a program is executed continuously, an error will
eventually occur.
(4) If an End Select statement that does not correspond to Select Case is executed, an execution error will
occur.
(5) It is possible to write While-WEnd and For-Next within a Case block.
(6) Use "Case IS", when using the comparison operators (<, =, >, etc.) for the "<Expression>".

Mitsubishi MELFA CR1D Specifications

General

Brand	Mitsubishi
Model	MELFA CR1D
Category	Controller
Language	English