Mitsubishi MELFA CR1D - Initialize the Parameter

3-79 Operation of setup / initialization screen
3Explanation of operation methods
4) Press the function key corresponding to "Close", and return to the set/initial screen.
(2) Initialize the parameter
Return the parameter to the setup at the time of shipment.
1) Press the [1] key in the set/initial screen, and display the initial menu screen.
2) Press the [2] key in the initial menu screen, and select the parameter. Display the screen of confirmation.
3) If it initializes, press the function key corresponding to "Yes". If it does not initialize, press the function key
corresponding to "no".
The screen returns to initiali menu screen.
<INITIALIZE>
1.DATA 2.PARAMETER
3.BATTERY
CLOSE
123
<SET/INITIALIZE>
1.INITIALIZE 2.POWER
3.CLOCK 4.VERSION
CLOSE
123
◇◆◇ Executed even when protected ◇◆◇
The program will be initialized even if the program protection or variable protection is set to ON.
<SET/INITIALIZE>
1.INITIALIZE 2.POWER
3.CLOCK 4.VERSION
CLOSE
123
<INITIALIZE>
1.DATA 2.PARAMETER
3.BATTERY
CLOSE
123
<INITIALIZE>
1.DATA
2.PARAMETER
3.BATTERY
CLOSE
123
<INITIALIZE>
INITIALIZE PARAMETER.
OK?
No
123
Yes
<INITIALIZE>
INITIALIZE PARAMETER.
OK?
No
123
Yes
<INITIALIZE>
1.DATA
2.PARAMETER
3.BATTERY
CLOSE
123