5Functions set with parameters
Operation parameter 5-358
Position
Restoration
Support
DJNT Real value 8
The OP correction data obtained by the Position Restoration
Support tool is input. Do not change it with any tool other than the
Position Restoration Support tool. It can only be referenced on a
dedicated parameter screen in the Personal Computer Support
software.
It varies with models.
MEXDTL Real value 6
The standard tool correction data obtained by the Position
Restoration Support tool is input. Do not change it with any tool
other than the Position Restoration Support tool.
(X,Y,Z,A,B,C) =
0.0, 0.0, 0.0,
0.0, 0.0, 0.0
MEXDTL1 Real value 6
The correction data for tool number 1 obtained by the Position
Restoration Support tool is input. Do not change it with any tool
other than the Position Restoration Support tool.
(X,Y,Z,A,B,C) =
0.0, 0.0, 0.0,
0.0, 0.0, 0.0
MEXDTL2 Real value 6
The correction data for tool number 2 obtained by the Position
Restoration Support tool is input. Do not change it with any tool
other than the Position Restoration Support tool.
(X,Y,Z,A,B,C) =
0.0, 0.0, 0.0,
0.0, 0.0, 0.0
MEXDTL3 Real value 6
The correction data for tool number 3 obtained by the Position
Restoration Support tool is input. Do not change it with any tool
other than the Position Restoration Support tool.
(X,Y,Z,A,B,C) =
0.0, 0.0, 0.0,
0.0, 0.0, 0.0
MEXDTL4 Real value 6
The correction data for tool number obtained by the Position
Restoration Support tool is input. Do not change it with any tool
other than the Position Restoration Support tool.
(X,Y,Z,A,B,C) =
0.0, 0.0, 0.0,
0.0, 0.0, 0.0
MEXDBS Real value 6
The correction data for the base obtained by the Position
Restoration Support tool is input. Do not change it with any tool
other than the Position Restoration Support tool.
(X,Y,Z,A,B,C) =
0.0, 0.0, 0.0,
0.0, 0.0, 0.0
Parameter
Parameter
name
No. of arrays
No. of characters
Details explanation Factory setting
To Next Page
Loading...
Need help?
General
