Mitsubishi MELFA CR1D User Manual

3-75 Operation of maintenance screen
3Explanation of operation methods
The value can be changed also in this state.
Press the function key corresponding to the "Data", make it move to the position of the element number
which changes the cursor by the arrow key, and input the new preset value. Delete the unnecessary
number by the [CLEAR] key.
If the [EXE] key is pressed, the buzzer will sound, the value will be fixed and it will return to the screen of
the parameter.
If the function key corresponding to the "Close" is pressed also after inputting the new preset value,
change can be canceled and it can return to the parameter screen.
<PARAMETER> NAME(MEXTL )
ELE(3 )
DATA
(100.00 )
CLOSE
123
Next
DATA
Prev
<PARAMETER> NAME(MEXTL1 )
ELE( )
DATA
(0.00,0.00,0.00,0.00,0.00,0.00 )
CLOSE
123
Next
DATA
Prev
<PARAMETER> NAME(MEXTL )
ELE( )
DATA
(0.00,0.00,100.00,0.00,0.00,0.00 )
CLOSE
123
Next
DATA
Prev
[F3]
[F2]
<PARAMETER> NAME(MEXTL )
ELE(3 )
DATA
(0.00,0.00,0.00,0.00,0.00,0.00 )
CLOSE
123
Next
DATA
Prev
<PARAMETER> (MEXTL ) ( )
0.00,0.00,100.00,0.00,0.00,0.00
CLOSE
123
Next
DATA
Prev
◇◆◇ Power must be turned ON again ◇◆◇
The changed parameter will be validated only after the controller power has been turned OFF and ON once.
◇◆◇ Only display is valid during program execution. ◇◆◇
If the setting value of the parameter is changed during execution of the program, the error will occur. (Even
if the error occurs, execution of the program does not stop)
◇◆◇ Display the parameter near the name of the inputted parameter. ◇◆◇
Even if the name of the parameter does not input all characters correctly, it displays the parameter near the
inputted name automatically.

Mitsubishi MELFA CR1D Specifications

General

Brand	Mitsubishi
Model	MELFA CR1D
Category	Controller
Language	English