Mitsubishi MELFA CR1D - Page 99

3Explanation of operation methods
Operation of the initial-setting screen 3-86
7) Press the [F1] key, and save the setup.
If not saved , press the [F2] key. All return to the initial-setting screen.
And, the setup can be done over again if the [EXE] key is pressed.
8) T/B starts in the contrast set up when the [EXE] key was pressed.
1.Save and Exit
2.Exit without Save
<1> <2> Prev
1.Configuration
2.Com.Information
<1> <2> Rset
1.Configuration
2.Com.Information
<1> <2> Rset
MELFA RV-12SQ-SZ Ver. 1.0
CRnQ-7xx
COPYRIGHT (C) 2007 MITSUBISHI ELEC
TRIC CORPORATION ALL RIGHTS RESE
RVED