8
UTILITY PACKAGE (GX Configurator-MB)
8.3 Utility Package Operation
8.3.1 Common utility package operations
8 - 9
1
OVERVIEW
2
SYSTEM
CONFIGURATION
3
SPECIFICATIONS
4
MODBUS(R) STANDARD
FUNCTIONS
5
FUNCTION
6
PRE-OPERATIONAL
PROCEDURES AND
SETTINGS
7
PARAMETER SETTING
8
UTILITY PACKAGE
(GX Configurator-MB)
Steps 1) to 3) in the figure are performed as shown below.
1) From GX Developer, select:
[Project] [Open project]/[Save]/[Save as]
2) On the intelligent function module selection screen of the utility, select:
[Intelligent function module parameter] [Open parameters]/[Save
parameters]
3) From GX Developer, select:
[Online] [Read from PLC]/[Write to PLC] "Intelligent function module
parameter"
Alternatively, from the intelligent function module selection screen of the utility,
select:
[Online] [Read from PLC]/[Write to PLC]
To Next Page
Loading...
