7 - 1
7.1 Parameter Settings and Setting Procedure
7
PARAMETER SETTING
CHAPTER7 PARAMETER SETTING
This chapter explains the setting of the parameters.
7.1 Parameter Settings and Setting Procedure
(1) Parameter types
(a) Automatic communication parameter
Set the automatic communication parameters when using the automatic
communication function with the QJ71MB91 operated as a master.( Section
7.2)
Up to 32 automatic communication parameters can be set for each channel.
If the automatic communication function is not to be used, setting of these
parameters are not required.
(b) MODBUS device assignment parameter
Set the MODBUS device assignment parameters when using the MODBUS
device assignment function with the QJ71MB91 operated as a slave.(
Section 7.3)
When using the initial values preset to the QJ71MB91, no setting is required for
these parameters.
(2) Parameter setting method
Set parameters to the QJ71MB91 by either of the following methods.
(a) Using utility package
Set the parameters from the GX Configurator-MB utility package.
( CHAPTER 8)
(b) Using sequence program
Set the parameters by a sequence program.( Section 9.1 to 9.3)
To Next Page
Loading...
