8 - 14
8.3 Utility Package Operation
8.3.3 Starting the Intelligent function module utility
8
UTILITY PACKAGE (GX Configurator-MB)
POINT
1. Saving intelligent function module parameters in a file
Since intelligent function module parameters cannot be saved in a file by the
project saving operation of GX Developer, save them on the shown module
selection screen.
2. Reading / writing intelligent function module parameters from / to a
programmable controller using GX Developer
• Intelligent function module parameters can be read from and written into
a programmable controller after having been saved in a file.
• Set a target programmable controller CPU in GX Developer:
[Online] [Transfer setup].
Only use the control CPU for the QJ71MB91 to write the intelligent
function module parameters for a multiple CPU system to the
programmable controller.
• When the QJ71MB91 is mounted on a MELSECNET/H remote I/O
station, [Read from PLC] and [Write to PLC] must be performed from GX
Developer.
3. Checking the required utility
While the start I/O is displayed on the Intelligent function module utility setting
screen, "*" may be displayed for the model name.
This means that the required utility has not been installed or the utility cannot
be started from GX Developer.
Check the required utility, selecting [Tools] - [Intelligent function utility] - [Utility
list...] in GX Developer.
To Next Page
Loading...
Need help?
General
