Mitsubishi QJ71MB91 - Page 270

9 - 41
9.3 Program Examples for Use in MELSECNET/H Remote I/O Network
9.3.2 MODBUS(R) device assignment parameters
9
PROGRAMMING
(c) MODBUS device assignment parameter
1) When using GX Configurator-MB
Set MODBUS device assignment parameter in the Initial setting of GX
Configurator-MB. ( Section 8.4.2)
Set the values shown in the settings. ( This section (2) (b))
Figure 9.45 MODBUS device assignment parameter
2) When not using GX Configurator-MB
Set MODBUS device assignment parameter from the sequence program.
( This section (4))