(1) Stylus moving direction
Indicates the stylus movement.
The moving direction lights in green.
(2) Stylus position
Indicates the stylus position.
Green lighting indicates that the stylus is located within the measuring range.
"+OR" lights in red when the stylus goes beyond the upper measuring range.
When the stylus is fixed on the highest position with the up switch, the LED blinks
in red.
"‒OR" lights up in red when the stylus falls below the lower measuring range.
Between "+OR" and "‒OR", the stylus position is indicated by lighting in green.
"OR" is an abbreviation of "Over Range".
Indicates an error status.
Refer to "5.2 Error Message" for further information.
Moves the stylus in the X-axis direction.
(1) Outer dial
A coarse adjustment dial. Twist of this dial allows the stylus to move in the X-axis
direction.
The moving direction and speed vary depending on the twist direction and amount.
(2) Inner dial
A fine adjustment dial. Rotation of this dial allows the stylus to move in the X-axis
direction.
The moving direction and speed vary depending on the rotation direction and
speed.
To Next Page
Loading...
