Monarch NICE7000 - Page 137

NICE7000 User Manual 7 Description of Function Codes
- 135 -
It is used to set the running speed in the operation panel control mode.
Note that this function is enabled only when F0-01 is set to 0 (Operation panel control). You
can change the running speed of the elevator by modifying this parameter during running
Function Code Parameter Name Setting Range Default Unit Property
F0-03
Maximum running speed 0.100 to F0-04
1.600 m/s ★
It is used to set the actual maximum running speed of the elevator. The value must be
smaller than the rated elevator speed.
Function Code Parameter Name Setting Range Default Unit Property
F0-04 Rated elevator speed 0.100–4.000 1.600 m/s ★
It is used to set the norminal rated speed of the elevator. The value of this parameter is
dependent on the elevator mechanism and traction motor.
Note
F0-03 is the actual running speed within the elevator speed range set in F0-04. For example, for a
certain elevator, if F0-04 is 1.750 m/s and the actually required maximum running speed is 1.600
m/s, set F0-03 to 1.600 m/s.
Function Code Parameter Name Setting Range Default Unit Property
F0-05
Elevator running direction 0–1
0 - ★
It is used to set the elevator running direction.
The values are as follows:
•
0: Direction unchanged
•
1: Direction reversed
Modify this parameter to reverse the running direction (without changing the wiring of the
motor).
When you perform inspection running for the rst time after motor auto-tuning is successful,
check whether the actual motor running direction is consistent with the inspection command
direction. If not, change the motor running direction by setting F0-05 to consistent with the
inspection command direction.
Pay attention to the setting of this parameter when restoring the default setting.
Function Code Parameter Name Setting Range Default Unit Property
F0-07
Carrier frequency 2.0–16.0 8.0
kHz ★
It is used to set the carrier frequency of the controller.
The carrier frequency is closely related to the motor noise during running. When it is
generally set above 6 kHz, mute running is achieved. It is recommended to set the carrier