Monarch NICE7000 - Terminal Wiring and Description of the MCTC-PG Card; Wiring between MCTC-PG-E and the Controller

NICE7000 User Manual 3 Mechanical and Electrical Installation
- 57 -
Encoder Type Adaptable PG Card Appearance
SIN/COS encoder MCTC-PG-E
J1
MCTC-PG-E
CN1
Absolute encoder
(ECN413/1313)
MCTC-PG-F1
J1
MCTC-PG-F1
CN1
3.6.2 Terminal Wiring and Description of the MCTC-PG Card
The MCTC-PG card is connected to the controller and the encoder as follows:
The J1 terminal and CN1 terminal of the MCTC-PG card are respectively connected to the
J12 terminal of the MCB on the controller and the encoder of the motor.
Different MCTC-PG card models are connected to the MCB in the same way. The
connection method to the encoder depends on the CN1 terminal of the model.
The following gure shows the wiring between MCTC-PG-E and the controller.
Figure 3-14 Wring between MCTC-PG-E and the controller
NICE7000
R
S
T
Three-phase AC
power supply
Safety
contactor
M
Regen. resistor
+
–
BR
U
V
W
PG card
EncoderMotor
J1
CN1
MCTC-PG-E
The following table denes the CN1 terminals of different MCTC-PG card models.