Monarch NICE7000 - Chapter 5 System Commissioning and Functions

4 Use of the Commissioning Tools NICE7000 User Manual
- 76 -
Figure 4-5 Operation procedure on the operation panel
F0
F0-06
50.00
(Select the function
code group)
(Select the
function code)
(Set the value of
the function code)
Level-I menu
Level-II menu
Level-III menu
PRG
PRG
Not to save
the setting
ENTER
To save
the setting
ENTER
0.000
ENTER
Status parameter
PRG
F0-07
ENTER
PRG
Next function
code
(default display)
If there is a blinking digit, press
/ / to modify the digit.
You can return to Level II menu from Level III menu by pressing
PRG
or
ENTER
. The
difference between the two is as follows:
•
After you press
ENTER
, the system saves the parameter setting first, and then goes
back to Level II menu and shifts to the next function code.
•
After you press
PRG
, the system does not save the parameter setting, but directly
returns to Level II menu and remains at the current function code.
The following gure shows the shift between the three levels of menus.
Figure 4-6 Shift between the three levels of menus
Fd
…FX-00
PRG
ENTER
FE
FP
F0
F1
F2
F3
FE-00
FE-56
FP-02
F0-07
F1-25
F2-18
F
3-21
FP-00
F0-00
F1-00
F2-00
F3-00
Fd-00
Fd-26
In Level III menu, if the parameter has no blinking digit, it means that the parameter cannot
be modied. This may be because:
•
Such a parameter is only readable, such as actually detected parameters and running
record parameters.
•
Such a parameter cannot be modied in the running state and can only be changed at
stop.