Ground
AC input reactor
Electromagnetic
contactor
Moulded case circuit breaker
(MCCB) or earth leakage
circuit breaker (ELCB)
Three-phase AC
power supply
Regen. resistor
Noise filter
on input side
P(+)
BR
Braking unit
+
-
Motor
External operation panel
Output
reactor
Ground
Ground
Use within the allowable power
supply specification of the
controller.
Select a proper breaker to resist
large in-rush current that flows into
the controller at power-on.
To guarantee safety, use an
electromagnetic contactor. Do not
use it to start or stop the controller
because such operation reduces
the service life of the controller.
Suppress the high order harmonic
to improve the power factor.
Reduce the
electromagnetic
interference on the
input side.
Reliably ground the
motor and the
controller to prevent
electric shock.
MF.K
RUN
STOP
RES
QUICK
PRG ENTER
RUN
LOCAL/REMOT FED/REV TUNE/TC
RPM
%
A VHz
MCTC-CTB
MCTC-CCB
MCTC-HCB
Car display
board
Voice
announcer
Bottom floor
Top floor
MCTC-HCB
R S T UV W
NICE7000
1. Do not install the capacitor or surge suppressor on the output side of the controller.
Otherwise, it may cause faults to the controller or damage to the capacitor and surge
suppressor.
2. Inputs/Outputs (main circuit) of the controller contain harmonics, which may interfere
with the communication device connected to the controller. Therefore, install an anti-
interference lter to minimize the interference.
3. Select the peripheral devices based on actual applications as well as by referring to
section 3.8.2.
The following table describes the peripheral electrical devices.
To Next Page
Loading...
