Monarch NICE7000 - Page 158

7 Description of Function Codes NICE7000 User Manual
- 156 -
Then, enter "63101" for F6-05 on the operation panel.
Function Code Parameter Name Setting Range Default Unit Property
F6-09 Elevator function selection 1 0–65535 32816 - ★
F6-10 Elevator function selection 2 0–65535 18 - ★
F6-11 Elevator function selection 3 0–65535 0 - ★
These parameters are used to select the required elevator functions. Each bit of the function
code denes a function, as described in the following table.
If a bit is set to 1, the function indicated by this bit is enabled; if this bit is set to 0, the
function is disabled.
The functions dened by the binary bits are described in the following table.
Bit Function Description Default
F6-09 Elevator function selection 1
Bit0 Disability function It is used to enable or disable the disability function.
0
Bit1
Disabling returning
to base oor for
verication
The function of returning to base oor for verication
due to large deviation of the car position is disabled.
0
Bit2 Re-leveling function
If the oor height is large or the car load is heavy, there
is a deviation between the car position and the oor sill
at arrival.
If this function is enabled, the elevator shorts the door
lock signal through the door lock circuit contactor, and
performs re-leveling at a low speed with door open.
The door pre-open module needs to be used together
for this function.
0
Bit3
Door pre-open
function
During normal stop, when the elevator speed is smaller
than a certain value and the door zone signal is active,
the system shorts the door lock by means of the
shorting door lock circuit contactor and outputs the door
open signal, implementing door pre-open. This improves
the elevator use efciency.
It requires use of a door pre-open module.
0
Bit4
Stuck hall call
cancellation
The system automatically identies the state of the hall
call buttons. If the state is abnormal, the system cancels
the stuck hall call.
0
Bit5 Peak service
When there are a large number of calls at a oor in
a certain period, the elevator returns to this oor and
waits.
0
Bit6
Down collective
selective peak
service
This function is similar to the peak service except that
the elevator responds to only down calls during the peak
period.
0
Bit7 Fault auto reset
The controller automatically resets the faults once every
hour.
0