Monarch NICE7000 - Page 7

Introduction NICE7000 User Manual
- 6 -
Hall I/O extension
function
If the hall I/O terminals are not sufcient, more terminals can be provided
by using an HCB-B board.
Car I/O extension
function
If the car I/O terminals are not sufcient, more terminals can be provided
by using an HCB-B board.
Button stuck check
The system can automatically identify whether a hall call button is stuck
and cancel the stuck call, preventing the condition that the elevator
cannot close and run due to stuck hall calls.
Automatic startup
torque compensation
The system automatically implements startup torque compensation based
on the current car load, achieving smooth startup and improving the riding
comfort.
Direct travel ride
The system automatically calculates and generates the running curves
based on the distance, enabling the elevator to directly stop at the
leveling position without creeping.
Automatic
generation of
optimum curve
The system automatically calculates the optimum speed curve compliant
with the human-machine function principle based on the distance, without
being limited by the number of curves or short oor.
Service suspension
output
When the elevator cannot respond to hall calls, the corresponding
terminal outputs the service suspension signal.
Running times
recording
In automatic running state, the system automatically records the running
times of the elevator.
Running time
recording
The system automatically records the accumulative power-on time,
working hours, and working days of the elevator.
Switchover of
parking oor
The main parking oor can be switched over by operating the related
switch or the switchover time is reached.
Automatic door
open upon door lock
abnormality
If the system detects that the door lock circuit is abnormal during door
open/close, the elevator automatically opens and closes the door again,
and reports a fault after the set door open/close times is reached.
VIP service
The elevator rst directly runs to the VIP oor and provides services for
special persons.
Specied elevator
preferred
The specied elevator is preferred to respond to calls of specied oors.
Disability service
When the elevator is waiting at the leveling position, if there is a call at
this oor from the disability operation box, the door open holding time is
prolonged. It is the same for the back door.
Full-load direct
running
When the car is full-loaded in automatic running state, the elevator
does not respond to hall calls from the passing oors. These halls calls,
however, can still be registered, and will be executed at next time of
running (in the case of single elevator) or by another elevator (in the case
of parallel/group control).
Overload protection
When the car load exceeds the rated elevator load, the elevator alarms
and stops running.
Elevator abnormality
protection
The system performs protection in time at abnormality, guaranteeing
elevator safety.