Motorola EP350 Basic Service Manual

Radio Programming and Tuning: Front Panel Programming 5-15
5.8.2.1.2 From User to Dealer
1. Turn off the radio.
2. Press the Side Programmable Button 2 (bottom side programmable button) 5 times within 3
seconds after turning on the radio.
3. LCD will display the current front panel programming mode.
4. If the LCD does not display "DEALER",
a. Press Left-arrow or Right-arrow buttons to scroll to "DEALER" mode.
b. Press PTT to confirm "DEALER" mode selection.
c. The LCD displays "DEALER MODE ON" for a while before showing “DEALER”.
5. Turn off the radio. The radio is now operating in DEALER MODE.
5.8.3 Entering Programming Mode
Make sure the radio is turn off. Press Side Programmable Button 1 (top side programmable button),
and turn ON the radio. A tone is heard, indicating that the radio is in Programming Mode. The
indicator illuminates and the "BCKLIGHT" is displayed on the radio LCD.
5.8.4 Exiting Programming Mode
Turn off the radio to exit Programming Mode.
5.8.5 Accessing Front Panel Programming Mode Parameters
Press or to scroll through the parameters for each menu or sub-menu item, or
Press PTT to select the menu or sub-menu item, or
Press Side Programmable Button 1 to either return to previous menu level or to exit the selection
parameter without change.
Important:
If the radio is to be given to the customer, REMEMBER to switch it back to operate in
User Configuration.

Motorola EP350 Specifications

General

Channel Capacity	16 channels
IP Rating	IP54
Drop Resistance	1.2 meters
Frequency Range	VHF: 136-174 MHz, UHF: 403-470 MHz
Battery Life	Up to 11 hours
Power Supply	7.5 V (Nominal)
Waterproof	Splashproof
Dimensions	127.6 x 62 x 42 mm (with standard battery)