Motorola EP350 Basic Service Manual

Radio Programming and Tuning: Front Panel Programming 5-23
5.8.7 Factory Reset
This feature allows you to erase certain programmable parameters and restore the radio to the
factory default settings. The radio, upon reset, clears all memory channels, and restores the default
settings of radio wide parameters.
1. Set the radio in Dealer Configuration (if it is operating in User Configuration).
2. Press and hold Side Programming Button 2 and PTT button together, while turning on the radio.
3. A good key tone is heard and “FA RESET” is displayed on the LCD
4. Proceed to step 8 to Cancel Factory Reset.
5. Press . “YES” is displayed.
6. Press PTT to confirm Factory Reset. “RESET OP” is shown while factory reset operation is in
progress.
7. Upon completion, “FACTORY RESET COMPLETED” is shown and the radio automatically turn
off and on again. The radio is now restored to its default factory setting.
8. Press . “NO” is displayed.
9. Press PTT to confirm Cancellation. “CANCELLED” is shown and the radio automatically turn off,
and on again.
Note:
Factory Reset function is only available for Software Mode 1 radio.

Motorola EP350 Specifications

General

Channel Capacity	16 channels
IP Rating	IP54
Drop Resistance	1.2 meters
Frequency Range	VHF: 136-174 MHz, UHF: 403-470 MHz
Battery Life	Up to 11 hours
Power Supply	7.5 V (Nominal)
Waterproof	Splashproof
Dimensions	127.6 x 62 x 42 mm (with standard battery)