http://www.mcg.mot.com/literature IN-5
I
N
D
E
X
PC/104-Plus
connector (P2), pinouts 6-23
dimensions 5-18
installation 1-7
interface 5-18
power consumption A-3
stacking 1-8, 5-19
PCI
activity LED 6-30
arbitration 5-19
connector (P2) 5-18
pinouts 6-23
Revision 2.1 5-18
PCI/ISA bridge controller 5-14, 5-19
PCI/ISA interface 5-18
PCMCIA
installation 1-7
interface 5-16, 6-10
performing diagnostics 2-4, 3-2
polyswitches 5-20
power
analog
connector (J28), pinouts 6-12
requirements 2-2
applying 2-1
connector (J12), pinouts 6-12
floppy disk drive 5-15
fused voltages 5-20
hard disk drive 5-20
keyboard/mouse 5-20
LCD panel 5-16
requirements A-2
status LEDs 6-30
power monitor circuit 5-13
PowerQUICC 5-7
preparing the board 1-3
processors, description 5-7
programming
console 1-7
Flash memory 3-6
programs
execution offset 4-4
loading 4-3
prompts 3-2
Q
QSpan 5-18, 6-8
R
R59 and R68 (fuses) 5-20
real-time clock 5-8
registers, PCI interrupts route control 4-3
related documentation B-1
related specifcations B-3
required equipment 1-1
reset switch 5-12
resetting the system 2-3, 5-13
RJ-45 socket, pinouts 6-16
route control registers 4-3
running programs 4-3
S
SCC (serial communication controller)
channels 5-17
SCC1 and Ethernet 5-15
selecting a boot device 6-6
serial
asynchronous 5-13
communications interface 1-6, 2-1,
5-14, 5-17, 5-18
handshaking 1-7
ports 1-6, 2-1
header (J18), pinouts 6-15
setting environment parameters 4-2
setting jumpers 6-3
setup overview 1-1
SMC (serial management controller)
channels 5-17
specifications
MBX board A-1
related B-3
SPI & LCD connector (J27), pinouts 6-22
To Next Page
Loading...
