7 - 22 MC70 Integrator Guide
Figure 7-32
Manage Profiles
Tap and hold a profile and select
Connect from the pop-up menu to set this as the active profile. Once selected,
the EDA uses the authentication, encryption, ESSID, IP Config, and power consumption settings configured for
that profile.
Editing a Profile
Tap and hold a profile and select Edit from the pop-up menu to display the Profile Wizard where you can set the
ESSID and operating mode for the profile. Use the
Profile Wizard to edit the profile power consumption and
security parameters. See Profile Editor Wizard on page 7-4.
Creating a New Profile
To create new profiles from the Manage Profiles window, tap-and-hold anywhere in this window.
Figure 7-33
Manage Profiles - Add
Select
Add to display the Profile Wizard wherein you can set the profile name and ESSID. Set security, network
address information, and power consumption level for the new profile.
Deleting a Profile
To delete a profile from the list, tap and hold and select Delete from the pop-up menu. A confirmation dialog box
appears.
To Next Page
Loading...
Need help?
General
