7 - 32 MC70 Integrator Guide
Known APs Window
The Known APs window displays the APs in range using the same ESSID as the EDA. This window is only
available in
Infrastructure mode. To open the Known APs window, tap Known APs in the Wireless Diagnostics
window.
Figure 7-44
Known APs Window
See Table 7-22 for the definitions of the icons next to the AP.
Tap and hold on an AP to display a pop-up menu with the following options:
Set Mandatory and Set Roaming.
Select
Set Mandatory to prohibit the EDA from associating with a different AP. The letter M displays on top of
the icon. The EDA connects to the selected AP and never roams until:
•
You select Set Roaming
•
The EDA roams to a new profile
•
The EDA suspends
•
The EDA resets (warm or cold).
Select
Set Roaming to allow the EDA to roam to any AP with a better signal. These settings are temporary and
never saved to the registry.
Tap
Refresh to update the list of the APs with the same ESSID. The highest signal strength value is 32.
Table 7-22
Current Profile Window
Icon Description
The AP is the associated access point, and is set to mandatory.
The AP is the associated access point, but is not set to mandatory.
The EDA is not associated to this AP, but the AP is set as mandatory.
The EDA is not associated to this AP, and AP is not set as mandatory.
To Next Page
Loading...
Need help?
General
