4 - 22 MC70 Integrator Guide
Misc(2) Tab
Use this tab to configure various miscellaneous features.
Figure 4-11
Misc(2) Tab
Table 4-9
Misc(2) Tab
Field Description
Auto-retry Use this field to specify whether the AirBEAM Smart Client automatically retries if
synchronization fails.
If this feature is enabled, the AirBEAM Smart Client displays a pop-up dialog indicating
the retry attempt. The pop-up dialog appears for the number of seconds specified in the
Retry Delay field.
Values for this field are:
-1: the AirBEAM Smart Client automatically retries indefinitely.
0: the AirBEAM Smart Client does not automatically retry.
-0: the AirBEAM Smart Client automatically retries up to the number of times specified.
Retry Delay This field specifies the amount of time, in seconds, that the AirBEAM Smart Client delays
before automatically retrying after a synchronization failure.
In-use Test This check box specifies whether the AirBEAM Smart Client tests to determine if a file is
in use before downloading. If the In-use Test feature is enabled, the AirBEAM Smart
Client downloads a temporary copy of any files that are in use. If any temporary in-use
files are downloaded the AirBEAM Smart Client automatically resets the client to
complete copying the in-use files. If the In-use Test feature is disabled, the
synchronization process fails (-813) if any download files are in use.
Wait Welcome This check box specifies whether the AirBEAM Smart Client waits for the WELCOME
windows to complete before automatically launching the synchronization process after
a reset.
Close Apps This check box specifies whether the AirBEAM Smart Client automatically attempts to
close non-system applications prior to resetting the mobile unit. If enabled the AirBEAM
Smart Client sends a WM_CLOSE message to all non-system applications before
resetting the mobile unit. This feature offers applications the opportunity to prepare (i.e.,
close open files) for the pending reset.
To Next Page
Loading...
Need help?
General
