Motorola Mototrbo - 11.6 Assembly and Reassembly; 11.6.1 Assembly - Detailed; 11.6.1.1 Back Panel Installation

Figure 57: Removing Ground Screw
5 Remove the five screws securing the back panel to the repeater chassis with a T10 Torx driver.
6 Remove the back panel from the repeater.
7 Remove the two rubber plugs from the back panel.
11.6
Assembly and Reassembly
11.6.1
Assembly – Detailed
11.6.1.1
Back Panel Installation
Procedure:
1 Using a T10 Torx driver, install five M3 x 0.5 x 6 mm screws (PN: 0310907A18) to 10 in-lb (1.1
N-m). See Figure 58: Installing M3 Screws on page 102.
Chapter 11: SLR 5000 Series Maintenance and Disassembly/Reassembly
Motorola Solutions Confidential
Send Feedback 101