Motorola Mototrbo - 6.3 Interfaces; 6.3.1 Modem Interface; 6.3.2 User;Service Interface; 6.3.2.1 USB

Label Description
3 USB Device Connector
4 USB Device Connector
5 LED Indicators
6.3
Interfaces
6.3.1
Modem Interface
The interface to the modem is made via a 30 pin flex cable. The connector on the front panel board is a
30 pin horizontal LIF connector. The location can be seen in Figure 22: Front Panel Input and Output
Connections on page 65.
6.3.2
User/Service Interface
6.3.2.1
USB
The Front Panel USB device port is the interface used for connecting the repeater to a computer in
order to use the Customer Programming Software. See Figure 22: Front Panel Input and Output
Connections on page 65 for the location. A standard “Type A” to “Type B” USB cable facilitates the
connection. See Appendix A : Accessories on page 129, Service Tools on page 131 for the noted
USB cable part number.
6.3.2.2
LED Indicators
The Front Panel houses 7 LED indicators used for displaying the state of the repeater. For state
details, refer to Table 9: SLR 5000 Series Front Panel LED Definitions on page 42.
Chapter 6: SLR 5000 Series Front Panel
Motorola Solutions Confidential
66 Send Feedback