Motorola Mototrbo - 3.5.4 Power Supply Interface Connector; 3.5.5 Expansion Board Interface Connector; 3.5.6 Chassis ID Interface Connector

Figure 11: Power Amplifier Interface Connector Pin Locations
Pin 1 Pin 20
3.5.4
Power Supply Interface Connector
The power supply digital interface utilizes a 15 pin Pico-ClaspTM connector. The location is detailed in
Figure 8: Modem Module Connector Locations on page 48. Figure 12: Power Supply Interface
Connector Pin Locations on page 53 shows the pin number locations.
Figure 12: Power Supply Interface Connector Pin Locations
Pin 15 Pin 1
3.5.5
Expansion Board Interface Connector
The expansion board interface utilizes a 30 pin vertical LIF connector. The location is detailed in
Figure 8: Modem Module Connector Locations on page 48. Figure 13: Expansion Board Interface
Connector Pin Locations on page 53 shows the pin number locations.
Figure 13: Expansion Board Interface Connector Pin Locations
Pin 1
Pin 30
3.5.6
Chassis ID Interface Connector
The Chassis ID utilizes an 8 pin vertical LIF connector. The location is detailed in Figure 8: Modem
Module Connector Locations on page 48.
Figure 14: Chassis ID Interface Connector Pin Locations on page 54 shows the pin number
locations. The repeater chassis information is necessary for warranty and purchased software features
so this must be connected.
Chapter 3: SLR 5000 Series Modem
Motorola Solutions Confidential
Send Feedback 53