Motorola Mototrbo - 11.5.2 Disassembly - Detailed; 11.5.2.1 Protective Cover Disassembly; 11.5.2.2 Front Housing Disassembly; 11.5.2.3 Cable Disassembly

If a unit requires more complete testing or service than is customarily performed at the basic
level, send the repeater or FRU to a Motorola Solutions Service Center.
The following disassembly procedures should be performed only if necessary.
11.5.2
Disassembly – Detailed
11.5.2.1
Protective Cover Disassembly
Procedure:
1 Remove the six screws on the Bottom Cover with a T10 Torx driver.
2 Detach the Bottom Cover.
3 Remove the six screws on the Top Cover with a T10 Torx driver.
4 Detach the Top Cover.
11.5.2.2
Front Housing Disassembly
Procedure:
1 Remove the three screws securing the Front Housing to the repeater chassis with a T10 Torx
driver.
2 Slightly lift the Repeater and rock the Front Housing away from the chassis.
Figure 49: Removing Front Housing from Repeater
11.5.2.3
Cable Disassembly
Prerequisites:
NOTICE: When disengaging flexible cables, pull parallel to the insertion direction of the cable to
avoid damaging the cables.
Procedure:
1
Disengage cable connecting Modem to Chassis ID module.
Chapter 11: SLR 5000 Series Maintenance and Disassembly/Reassembly
Motorola Solutions Confidential
96 Send Feedback