Radio Tx
The SLR 5000 Series Repeater’s transmitter will yield 60% RSD with 80mV rms into the Tx Audio port.
The “Radio Tx” signal delivered by the Remote Tone Adapter is at a high enough drive level to leave
jumper S9 in the factory default position (position A).
Channel Steering
Leave jumper S7 in position B (factory default) to match the SLR 5000 Series Repeater’s active low
setting for the Channel Steering 1, Channel Steering 2, Channel Steering 3, and Channel Steering 4
GPIO signaling.
Monitoring
Leave jumper S8 in the “IN” position (factory default) to match the SLR 5000 Series’ active low setting
for the Monitor GPIO signaling.
PTT
Leave jumper S5 in the “IN” position (factory default) to match the SLR 5000 Series’ active low setting
for the PTT GPIO signaling.
Wildcard 1 (optional)
Leave jumper S6 in position A (factory default) to match the SLR 5000 Series’ active low setting for the
Repeater Disabled GPIO signaling.
Trunking Controllers
Description
The SLR 5000 Series Repeater is capable of supporting LTR trunking operations with the Trident’s
Marauder and Raider controllers. Additionally, the SLR 5000 Series Repeater also supports Passport
trunking as well with Trident’s NTS controller.
See respective Trident Instruction Manuals (supplied with the controllers) for specifications, operation,
installation, alignment, programming, and repair information.
Figure 95: Model Trident’s Marauder
Figure 96: Model Trident’s Raider
Appendix D : SLR 5000 Series Third-Party Controllers
Motorola Solutions Confidential
148 Send Feedback
To Next Page
Loading...
