Figure 71: Installing Fan
NOTICE: For each of the fans, look inside the fan shroud to ensure both the top and
bottom fan mounting bracket tabs are fully engaged with the protrusions (teeth) of the
base frame.
5 Connect the three fan cables to their corresponding jumper cables.
11.6.1.7
Front Panel Installation
Procedure:
1 Place the Front Panel (Kit Number: PMLN6490A) onto the corresponding bosses on the
repeater frame.
2 Install the three M3 x 0.5 x 6 mm screws (PN: 0310907A18) to 10 in-lb (1.1 N-m) in the order
shown in Figure 72: Installing Front Panel on page 108 using a T10 Torx driver.
Figure 72: Installing Front Panel
11.6.1.8
Cable Installation
Prerequisites:
CAUTION: Do not over torque the power screws as damage may occur.
Chapter 11: SLR 5000 Series Maintenance and Disassembly/Reassembly
Motorola Solutions Confidential
108 Send Feedback
To Next Page
Loading...
