Motorola Mototrbo - Trademarks

To Next Page

To Previous Page

Trademarks

MOTOROLA, MOTO, MOTOROLA SOLUTIONS and the Stylized M logo are trademarks or registered

trademarks of Motorola Trademark Holdings, LLC and are used under license. All other trademarks are

the property of their respective owners.

2016 Motorola Solutions, Inc.

Notice Foreword

Motorola Solutions Confidential

4 Send Feedback

Main Page

Foreword3
- General Safety Precautions3
- Computer Software Copyrights3
- Document Copyrights3
- Disclaimer3
- Trademarks4
General Safety and Installation  Standards and Guidelines5
MOTOTRBO SLR 5000 Series Repeater  Supplemental Safety and Installation Requirements7
Environmental Information9
- Material Content9
- Disposal of your Electronic and Electric Equipment9
- Disposal Guideline9
Document History11
Contents13
List of Figures21
List of Tables25
Summary of Bands Available27
Commercial Warranty29
- Limited Warranty29
SLR 5000 Series Repeater33
- 1.1 Notations Used in This Manual33
- 1.2 Description33
- 1.3 Operating Features35
- 1.4 Frequency Ranges and Power Levels37
- 1.5 Specifications37
- 1.6 Theory of Operation39
- 1.7 Basic Repeater Level Troubleshooting – RDAC and LEDs41
- 1.8 Repeater Model Numbering Scheme43
- 1.9 Model Chart43
  - 1.9.1 VHF High Power43
  - 1.9.2 UHF1 High Power44
SLR 5000 Series Satellite Receiver45
- 2.1 Description45
- 2.2 Operating Features45
- 2.3 Frequency Ranges45
- 2.4 Specifications45
- 2.5 Configuration45
- 2.6 Basic Station Level Troubleshooting – RDAC and LEDs46
- 2.7 Model Chart46
SLR 5000 Series Modem47
- 3.1 Description47
- 3.2 Receiver Subsystem49
  - 3.2.1 Description49
  - 3.2.2 Specifications49
- 3.3 Transmitter Exciter Subsystem50
  - 3.3.1 Description50
  - 3.3.2 Specifications50
- 3.4 Station Control Subsystem51
- 3.5 Station Control Interface52
SLR 5000 Series Power Amplifier55
- 4.1 Description55
  - 4.1.1 General Description55
- 4.2 Input and Output Connections55
- 4.3 Frequency Ranges56
- 4.4 Specifications56
- 4.5 Modem Interface57
SLR 5000 Series Power Supply59
- 5.1 Description59
  - 5.1.1 General Description59
- 5.2 Specifications60
- 5.3 Power Supply Interface61
SLR 5000 Series Front Panel65
- 6.1 Description65
  - 6.1.1 General Description65
- 6.2 Input and Output Connections65
- 6.3 Interfaces66
  - 6.3.1 Modem Interface66
  - 6.3.2 User/Service Interface66
    - 6.3.2.1 USB66
    - 6.3.2.2 LED Indicators66
SLR 5000 Series Back Panel67
- 7.1 Description67
  - 7.1.1 General Description67
- 7.2 Back panel Interfaces68
SLR 5000 Series Test Equipment And Service Aids77
- 8.1 Recommended Test Equipment77
- 8.2 Service Aids77
SLR 5000 Series Performance Check or Testing79
- 9.1 General79
- 9.2 Transmitter Testing79
- 9.3 Receiver Testing81
- 9.4 Auto Test and Tune Support83
SLR 5000 Series Programming and Tuning85
- 10.1 Introduction85
- 10.2 Customer Programming Software Setup85
- 10.3 Reference Oscillator Alignment86
  - 10.3.1 Tuning Procedure86
- 10.4 Repeater Tuning Setup87
- 10.5 Rx Audio Level Set87
  - 10.5.1 Tuning Procedure87
- 10.6 Tx Audio Level Set88
  - 10.6.1 Tuning Procedure88
- 10.7 Modulation Limit Alignment89
- 10.8 Changing to Battery Charger Only Mode92
SLR 5000 Series Maintenance and Disassembly/Reassembly93
- 11.1 Introduction93
- 11.2 Routine Maintenance93
- 11.3 Preventive Maintenance93
  - 11.3.1 Inspection93
  - 11.3.2 Cleaning Procedures93
- 11.4 Safe Handling of CMOS and LDMOS Devices94
- 11.5 Disassembly95
  - 11.5.1 Disassembly – General95
  - 11.5.2 Disassembly – Detailed96
- 11.6 Assembly and Reassembly101
  - 11.6.1 Assembly – Detailed101
- 11.7 Exploded Mechanical View111
- 11.8 Parts List112
- 11.9 Torque Charts113
SLR 5000 Series Installation115
- 12.1 Pre-Installation Considerations115
- 12.2 Mechanical Installation122
  - 12.2.1 Equipment Unpacking and Inspection122
  - 12.2.2 Mounting Procedures122
- 12.3 Electrical Connections124
  - 12.3.1 Power Supply Connections125
- 12.4 Post Installation Checklist127
- 12.5 Installing Repeater Hardware Options127
  - 12.5.1 General Bonding and Grounding Requirements127
  - 12.5.2 General Cabling Requirements128
Appendix A : Accessories129
- Introduction129
Appendix B : Replacement Parts Ordering133
- Replacement Parts Ordering133
Appendix C : Motorola Service Centers135
- Motorola Service Centers135
Appendix D : SLR 5000 Series Third-Party Controllers137
- Overview137
- Community Repeater Panel137
- Phone Patch141
- Tone Remote Adapter144
- Trunking Controllers148
Appendix E : Audio Enhancement153
- Overview153
Appendix F : MOTOTRBO Repeater – EME ASSESSMENT155
- Executive Summary155
- Exposure Prediction Model155
  - Exposure in Front of the Antenna155
  - Exposure at Ground Level157
- Typical System Configuration158
- Exposure Limits158
- EME Exposure Evaluation158
  - Exposure in Front of the Antenna158
  - Exposure at Ground Level159
- Compliance Boundary Description159
- Product Put In Service159
- References160
Glossary of Terms and Acronyms161
- Alert tone161
- Analog161
- ASIC161
- AUX161
- Band161
- CTCSS161
- Clear161
- Conventional161
- CPS161
- Default161
- Digital161
- DPL161
- DSP162
- EIA162
- ESD162
- EU162
- FCC162
- FM162
- Frequency162
- FRU162
- FSK162
- GNSS162
- GPIO162
- IC162
- IF162
- I/O162
- kHz163
- LCD163
- LED163
- MDC163
- MHz163
- MISO163
- MOSI163
- PA163
- PC Board163
- PFC163
- PL163
- Programming Cable163
- PTT163
- Receiver164
- Repeater164
- RF164
- RSSI164
- Rx164
- SCM164
- SELV164
- Signal164
- SINAD164
- SLR164
- Spectrum164
- SPI164
- Squelch164
- TOT165
- TPL165
- Transceiver165
- Transmitter165
- Trunking165
- Tx165
- UHF165
- USB165
- VCO165
- VCTCXO165
- VHF165
- VIP165
- VSWR165
- WLAN165

Motorola Mototrbo - Trademarks

Table of Contents

Other manuals for Motorola Mototrbo

Related product manuals