Motorola Mototrbo - 10.3 Reference Oscillator Alignment; 10.3.1 Tuning Procedure

Figure 40: Front view of SLR 5000 Series Repeater
1
Table 35: Callout Legend
Label Description
1 USB Port
Figure 41: Rear view of SLR 5000 Series Repeater
1
2
3 4 5
Table 36: Callout Legend
Label Description
1 AC Inlet Connector
2 DC Inlet Connector
3 Aux Connector
4 Rx RF Connector
5 Tx RF Connector
10.3
Reference Oscillator Alignment
This feature is used to adjust the reference oscillator of the repeater. This alignment process should be
done as maintenance schedules and regulations require or if the Modem FRU has been replaced in
the repeater.
10.3.1
Tuning Procedure
Procedure:
1 Connect the repeater’s transmitter antenna port to the Communication Analyzer.
Chapter 10: SLR 5000 Series Programming and Tuning
Motorola Solutions Confidential
86 Send Feedback