• When a repeater is delivered from Motorola Solutions, it arrives in suitable packing materials. If the
unpacked equipment is damaged, return it to Motorola Solutions in its original packaging.
CAUTION: Equipment should be handled in its original packaging until it is delivered to its
final destination. If the equipment is damaged while being moved without the original
packaging, the warranty claim is not valid.
12.2
Mechanical Installation
12.2.1
Equipment Unpacking and Inspection
Remove repeater from cardboard box. Remove foam corners and remove repeater from antistatic bag.
NOTICE: Antistatic plastic bags and foam corners should be kept for future shipping/
transporting of repeater.
Thoroughly inspect the equipment as soon as possible after delivery. If any part of the equipment has
been damaged in transit, immediately report the extent of the damage to the transportation company
and to Motorola Solutions.
When a repeater is delivered from Motorola Solutions, it arrives in suitable packing materials. If the
unpacked equipment is damaged, return it to Motorola Solutions in its original packaging.
CAUTION:
Equipment should be handled in its original packaging until it is delivered to its final destination.
If the equipment is damaged while being moved without the original packaging, the warranty
claim is not valid.
Improper handling of the repeater may cause personal injury or damage to the repeater.
12.2.2
Mounting Procedures
The repeaters can be mounted in the selected cabinet or rack, and may be installed by following the
procedures below.
12.2.2.1
Transferring Equipment from Shipping Container to Rack or Cabinet
As mentioned under Equipment Unpacking and Inspection, a repeater can be shipped in a box. Upon
delivery, the equipment must be removed from the container and transferred to a rack or cabinet.
NOTICE: Cabinets and racks must have mounting rails and hole spacing compatible with EIA
Universal 48.3 cm (19 in.) specifications. Cabinets must provide adequate ventilation (as
detailed under Equipment Ventilation) and must meet the following criteria:
41.3 cm (16.25 in.) deep
48.3 cm (19 in.) wide
13.4 cm (5.25 in.) high
Two mounting rails 5 cm (2 in.) from front of cabinet with front mounting holes
5.7 cm (2.25 in.) apart (center to center).
Contact Motorola Solutions Customer Support for specific questions regarding mounting equipment in
customer-supplied cabinets.
Chapter 12: SLR 5000 Series Installation
Motorola Solutions Confidential
122 Send Feedback
To Next Page
Loading...
