Figure 69: Installing M4 Screws
4 Snap the fan jumper cables into the chassis for the Power Supply, Modem, and Power Amplifier
fans.
Figure 70: Snapping Fan Cable
11.6.1.6
Fan Installation
Procedure:
1 Orient the fan module so that the cables are out at the lower left. See Figure 71: Installing Fan
on page 108.
2 Rest the bottom tab of the mounting bracket onto the main frame opening with proper
orientation.
3 Push the fan assembly towards the main frame until both tabs are fully snapped and engaged.
Two audible snaps should be heard.
4
Repeat the steps above for the remaining two fans.
Chapter 11: SLR 5000 Series Maintenance and Disassembly/Reassembly
Motorola Solutions Confidential
Send Feedback 107
To Next Page
Loading...
