Chapter 10
SLR 5000 Series Programming and
Tuning
10.1
Introduction
This chapter provides an overview of the MOTOTRBO Customer Programming Software (CPS) and
the MOTOTRBO Tuner application for use on Windows 7
™
, Windows 8
™
, or Windows 8.1
™
. These two
MOTOTRBO applications are used for the configuration and alignment of the SLR 5000 series
repeater.
10.2
Customer Programming Software Setup
The Customer Programming Software setup, shown in Figure 39: Customer Programming Software
Setup on page 85 is used to program the repeater. See Figure 40: Front view of SLR 5000 Series
Repeater on page 86 and Figure 41: Rear view of SLR 5000 Series Repeater on page 86 for the
actual connectors on the front and rear panels of the repeater.
NOTICE: See appropriate program on-line help files for the programming procedures.
CAUTION: Computer USB ports can be sensitive to Electronic Discharge. Employ proper ESD
practices (wrist strap, grounding, etc.) and do not touch exposed contacts on cables when
connected to a computer.
Figure 39: Customer Programming Software Setup
Front Panel
USB
AC
USB
120 / 240 VAC
Station
Tx Port
(N-type Female)
Rx Port
(BNC Female)
AUX
DC
13.6 VDC
Standard Type “A” to Type “B” USB cable
Rear Panel
Either
One or Both
SLR 5000 Series Programming and Tuning
Motorola Solutions Confidential
Send Feedback 85
To Next Page
Loading...
