Motorola Mototrbo - SLR 5000 Series Back Panel; 7.1 Description; 7.1.1 General Description

Chapter 7
SLR 5000 Series Back Panel
7.1
Description
The Back Panel interface provides the electrical interconnection interface between the SLR 5000
series repeater and the end user’s system. This includes the connectors necessary to interface the
repeater to RF peripheral equipment, power system, system controllers, LANs, as well as other
communications and maintenance equipment. This section provides a general description,
identification of inputs/ outputs, and a pin-out listing for all connectors, including information on signal
names, functions, and levels.
7.1.1
General Description
Figure 23: Back Panel Connector Names and Locations on page 67 shows the various interface
connector locations. Table 25: Connector Type and Primary Function on page 67 lists the connector
types as well as its primary function.
Figure 23: Back Panel Connector Names and Locations
1
2
3
4
5
6
8
7 11
9
10
12
Table 25: Connector Type and Primary Function
Location Connector Type Function(s)
1 C14 (IEC 60320) AC Power Inlet and Repeater Power Switch
2 Molex 42818-0212 DC Power Inlet and DC Charger Outlet
3 Option Dependent Option Dependent 1
4 Option Dependent Option Dependent 2
5 Type A Socket USB
6 RJ-45 – Jack Ethernet 2
7 RJ-45 – Jack Ethernet 1
8 DB25 – Female Aux: Rx Audio, Tx Audio, PTT, COR, Accessory Power, 1 PPS, and
GPIO
Table continued…
SLR 5000 Series Back Panel
Motorola Solutions Confidential
Send Feedback 67