Motorola Mototrbo - 7.2.6 Ethernet 1; 7.2.7 Ethernet 2

Figure 29: USB Connector
1
4
Table 29: USB Connector
Location Pin Assignment Type Signal Characteristics
1 VBUS
USB Physical
Layer
+5 VDC
2 D- 3.6 V differential data
3 D+
4 GND Ground
7.2.6
Ethernet 1
Fully compliant with IEEE and 802.3 and 802.3u standards. Supports 10Base-T, 100Base-Tx rates, full
duplex, half duplex mode and flow control. See the following figure and table for location of the pins
and the functional characteristics of the connector's pins.
Figure 30: Ethernet 1 Connector
1
8
Table 30: Ethernet 1 Connector
Location Pin Assignment Type Signal Characteristics
1 Ethernet Tx+
Ethernet
Physical Layer
5 V differential data
2 Ethernet Tx-
3 Ethernet Rx+
4 Unused N/A
5 Unused N/A
6 Ethernet Rx- 5 V differential data
7 Unused N/A
8 Unused N/A
7.2.7
Ethernet 2
Not supported at this time. Fully compliant with IEEE and 802.3 and 802.3u standards. Supports
10Base-T, 100Base-Tx rates, full duplex, half duplex mode and flow control. See the following figure
and table for location of the pins and the functional characteristics of the connector's pins.
Chapter 7: SLR 5000 Series Back Panel
Motorola Solutions Confidential
70 Send Feedback