USER MANUAL OPTIMA 7
19 / 78 MRU GmbH, D-74172 Neckarsulm
5 First usage
After the analyzer has been inspected and is ready for start-up it can be
switched on and personalized settings can be entered. These settings can
be changed at any time.
5.1. Preparatory steps
► Unpack the analyzer.
► Read the User Manual completely.
► The analyzer leaves the factory assembled and ready for use.
Nevertheless, check the device for completeness and integrity.
► Charge the battery of the analyzer for about 8 hours.
► Check date and time. Modify if needed.
5.2. Analyzer settings
The “Settings” menu allows configuring some instrument specific pa-
rameters.
In the main menu “EXTRAS“= “F3 key” - scroll down to “Settings“ then
press the “OK“ key. By selecting a line, the parameter value can be
changed by the arrow keys.
To Next Page
Loading...
